MacTCP Setup

Back to MacTCP / MacPPP Setup
Page 1 | Page2 | Page 3

Step 3: Configure TCP/IP

PPP manages your PPP connection. You use it to dial GDN via your modem and hang up when you are through, using the ConfigPPP Control Panel.

Open your Control Panels folder, then double click on the ConfigPPP Control Panel.

The most recent version (1.0.5) looks like this:

For now, leave this window configured according to the example -- unless your modem is connected to the printer port (In this case, change the Port Name: PopUp so it says Printer Port).

The PPP Server PopUp lists about 40 of the most popular modems. Select your modem by holding the mouse over this PopUp and dragging until you find it, then release the mouse.

When you have selected your modem, click the Config... button.

This brings up the following window which lets you enter a little more information:

Click in the Phone Num text box and type the modem mumber you call to connect to GDN (371-1368).
TIP: If you have call waiting, put *70, (star 70 comma) just before the number.

Also make the necessary change for the Port Speed Setting:
For a 14.4 Modem set the Port Speed at 57600
For a 28.8/33.6 Modem set the Port Speed at 115200

Click the Authentication... button. This brings up the Authentication window which lets you enter your username and password.

TIP: Usernames and passwords are Case Sensitive -- be careful how you type them in. Only type your username in the Auth ID Text Box. Do not add anything else (, etc.) or you will not get in!

Click the OK button.

Click the Done button in resulting window. This brings you back to the main ConfigPPP window:

Click the close box at the topleft of the ConfigPPP window.

Using your mouse, go to the Special menu and select Restart.


Page 1 | Page2 | Page 3